Prep the house. Wash the walls, remove wallpaper, patch, spackle, seal stains, dry and sand before you attempt to paint. Now is also the time to apply painters tape for trimming, lay drop cloths, etc. Remove all outlet and light switch face plates, collecting screws in a zip-top bag (good opportunity to wash the face plates all at once as well).[4] You can also buy your paint at this time. Don't wait until the last minute. It can take hours to mix many gallons of all your colors. Remember that traffic triples at your home-supply and hardware stores on weekends. Buy on a weekday if possible.
Carefully consider the gloss level. The shiny gloss paints are easy to clean, but will make any wall blemish stand out. The flat paints will help disguise wall blemishes, but can be difficult to clean. Generally, you'll want glossier paints where there's lots of steam or cooking (baths and kitchens) and in high-traffic areas. Flatter paints are preferred for large walls and ceilings. House Painting
The thick canvas stays in place, so you don’t need to tape it, and you can use it to cover any surface. Plastic drop cloths are slippery to walk on or set a ladder on and don’t stay in place. Even worse, paint spills on plastic stay wet, and they can end up on your shoes and get tracked through the house.  Canvas is slippery on hard floors, so rosin paper is better over vinyl, tile and hardwood. Tape the sheets together and to the floor to provide a nonslip surface. House Painting

The thick canvas stays in place, so you don’t need to tape it, and you can use it to cover any surface. Plastic drop cloths are slippery to walk on or set a ladder on and don’t stay in place. Even worse, paint spills on plastic stay wet, and they can end up on your shoes and get tracked through the house.  Canvas is slippery on hard floors, so rosin paper is better over vinyl, tile and hardwood. Tape the sheets together and to the floor to provide a nonslip surface. House Painting

Walls should be wet down before getting scrubbed, then washed with a gallon of water mixed with 1 cup chlorine bleach and 1 cup of either a concentrated, phosphate-free cleaner, such as a trisodium phosphate (TSP) substitute, or Jomax House Cleaner. Working in sections, from the bottom to the top, will avoid streaks. Be sure to rinse walls well before the solution dries. Wood siding and trim should be ready to paint after a day or two of dry weather. House Painting

When painting a carpeted room, keep in mind that paint will soak through drop cloths. This is especially true of the cheaper, lightweight cloths. It helps to tape masking paper to all of the base boards before laying the drop cloths. Tuck the edges of the cloth under the paper--this will help keep it clean. You might want to invest in a hand-held masking machine--they make the job go much faster. Even after taking these precautions make sure to clean big drops or spills before they soak through and before you step on them! House Painting
There's an insurmountable number of popular interior paint colors you can choose. Deciding which shade is one thing, and figuring out what room to cover it in is a whole other beast. That is why we narrowed down your choices to a handful of tried and true shades favored by decorating experts for various rooms to help make your decision a little easier. House Painting
Prime. Dark colors, stains (once sealed), and previously unpainted surfaces (drywall, spackle, etc.) will need a primer coat, usually white. NOTE: most paint stores & home improvement centers will now tint primer (at no charge) to match fairly close to the color of the finished coat, that way two coats of primer need not be applied.[6] Although not all surfaces need a prime coat, skip this step at your peril! Dark colors will likely show through the first -- or even the first couple-- topcoats of paint. Sealants and unpainted surfaces like spackle patches will absorb or repel moisture in a topcoat at a different level than the areas surrounding them. Applying a good primer coat will help even out these differences. Primer equalizes a wall to a uniform surface. It's like erasing a canvas before drawing a new picture. Although some will argue the point, you generally don't need to spend a great deal on primer or buy special primer. A cheap, 5 gallon (18.9 L) bucket of plain, flat white paint will usually do the trick and cover a large area. Give your primer at least 24 hours to dry (follow its instructions) before applying a topcoat. House Painting
Deciding which paint to use has gotten much easier now that acrylic latexes have pushed oil-based paints almost to extinction. The acrylics offer superior performance (they don't harden with age, the way oils do, so they move and breathe without blistering), they don't mildew as readily, and they emit fewer VOCs, so they comply with new air-quality regulations. They also work over both oil- and water-based primers. House Painting
BEHR Premium Cabinet and Trim Interior Semi-Gloss Enamel BEHR Premium Cabinet and Trim Interior Semi-Gloss Enamel offers excellent flow and leveling and dries to a hard, durable finish. Its outstanding block resistance allows for quick return to service, making it ideal for use on cabinets, trim, doors, windows, shutters and woodwork. This product can also be used on other properly prepared and primed substrates, such as drywall, masonry and metal.  More + Product Details Close House Painting
The BEHR PREMIUM PLUS 2 gal. Flat Interior The BEHR PREMIUM PLUS 2 gal. Flat Interior Ceiling Paint is designed for use on textured popcorn and acoustic-style ceilings. This splatter-resistant paint offers great hiding performance for coverage of up to 800 sq. ft. Its mildew-resistant finish helps ensure that the matte sheen lasts over time.  More + Product Details Close
Plan the schedule. Get a grip on the time it will take to bring the project to fruition. Plan for time to move furniture, wall prep, cut in, the painting itself, eating and breaks, and don't forget cleanup and bringing furniture back in. As you plan, err on the side of prudence. Unforeseen events will slow you down, so allow time for these. Remember, this is a multi-day project. Don't try to fit too much into a day. If you move faster than planned, great!

If less than half the old paint is left, however, it may be worth stripping it all off. Guertin gets rid of stubborn remnants using shrouded grinders (like the PaintShaver), infrared paint strippers (such as the Speedheater), or chemical strippers (like Multi-Strip), then smooths the wood with a course or two of sanding. When siding (or bank accounts) can't take the shock of a total strip job, Rich O'Neil, of Masterwork Painting in Bedford, Massachusetts, has successfully hidden rough, well-adhered paint under Peel Bond, a thick primer. House Painting
×